The main goals were to strip out the paper feed mechanism with its associated rotary encoding wheel and optical encoder, and get down to the linear print head driver with its position sensor/encoder strip. Along the way I also uncovered a small motor and encoder wheel in the ink waste tray, and the stepper motor for the scanner head. this last was especially nice as it came out with its gears, belt drive, and linear bearing axle in one unit. I took some not very useful pictures to document the teardown: http://www.flickr.com/photos/mrigneous/sets/72157608191419120/
I already have the paper feed motor running off the Adafruit motor shield and am working on how to connect the quadrature encoder to measure angle and direction of motion. The encoder device itself is dead simple to use as it is on its own little breakout board and only requires 4 wires +, GND, and two channels of signal (so only 2 i/o pins on the arduino). The challenge I am facing is figuring out which pins are used by the motor shield, and if they are the ones that support the interrupt(s) I need to manage the encoder. I will post more pics and code as I get that worked out. If I am successful (fingers crossed) then the same should be usable for the linear mechanism of the print head. In the end I hope to have a general purpose set up for reusing printer internals.I also took apart an old lexmark printer and it had a very simple stepper controlled print head. The Motor shield really shines here as it took me all of five minutes to get the stripped down print head shuttling back and forth with microstepped accuracy and smoothness. I took a little video (not much plot, but there ya go).
